Introduction: volumetric refrigeration oil filling machine for piston type semi-automatic filling machine, mainly used for for filling all kinds of oil viscosity.

Principle and features:

1. It is through the reciprocating movement of the cylinder, a piston and the principle of the 3-way switch valve to extract, extrusion materials, to switch control cylinder stroke, can adjust the filling quantity. Is the ideal alternative equipment for manual work.

2. This equipment has simple and reasonable structure, simple operation, high accuracy, etc.

3. The material contact parts adopt stainless steel, in line with the GMP requirements.

4. The filling volume and filling speed can be adjusted, and the filling precision is high.

5. The filling valve head adopts drip tight, wire drawing and filling lifting device.

Installation and debugging:

1. The volume type lubricating oil filling machine when unpacking the case according to the instruction to install, and turn on the compressed air source, air pressure is 0.6 MPa, as in the compressed air pipe main meet first to install the valve.

2. Open the door spin right out of the oil mist detector for oil standard to clean, or sewing machine oil, note: come on can't bring pressure, oil amount shall not exceed the highest scale.

(3) examine the seal face is flat into the air, adjust the pressure to adjust the volume of feed 0.3 0.4 MPa, general action if a drop of oil injection after one thousand times: regular check injection.

4. Filling quantity adjustment: rotary filling quantity first adjust the handwheel, observe the instructions window scale, make the needed to achieve the load, at the same time adjust the suction feeding and discharging speed to achieve satisfactory filling effect, use standard measuring filling amount, the most

Cleaning requirements:

Comprehensive cleaning before operation, add detergent with soft non-woven cloth to wipe the grease or dirt, and then use non-woven soft dry cloth. In accordance with the GMP requirements, inspection equipment and material contact part is in line with the corresponding requirement of clean, rinse and dry if did not meet again. The cleaning method according to the technological requirements.
 

The main parameters:

Filling Numbers: 1-18

2 filling capacity: 5-50 m1, 20-100 ml, 50-500 ml, 200-1000 m1, 1000-5000 ml.

Power: 220 v / 380 v 0.5 Kw

4 filling error: 1%

5 air requirements: stable 0. 4 mpa - 0. 65 mpa gas source